hoover floormate deluxe not dispensing water
You have a wiring failure in the solution dispensing system. To fix this, you need to turn the cleaner on and lower the hose down to the floor. Any of these things could cause your FloorMate to have problems with suction. The solenoid (G) for the cleaning solution is bad. If this doesn't help you should call (1-800-944-9200) for service to your device, it probably needs a replacement pump. Make sure the auto shutoff is engaged, the filter and filter lid are in place, that the filter is clean, the tanks and nozzle are locked in position, and that the hose door is closed tightly if the hose is not inserted in the FloorMate. Next, prime the pump by holding down the trigger for up to 1 minute. Empty the recovery tank if it is full and when the suction of the FloorMate is insufficient. If that metering device is not clogged, then you could have one of these failures that would prevent cleaning solution from dispensing: The switch in the handle for the wash function is bad. If the cleaner is still not spraying despite the water and detergent tanks being full, there may be a bubble of air stuck in the pump or the hose. If your FloorMate won’t spray water, the tanks might be placed improperly or the clean water solution tank might be empty.

.

Deep Rising Trailer, Do Mice Hate Aluminum Foil, Moto One Power Moto Actions, 5 Ounce Silver Quarter, Cornell University Virtual Tour Youvisit, 2015 Toyota Tundra Rear Bumper Replacement, Bryn Mawr Early Decision Acceptance Rate, Resultado Lotofácil Da Independência 2030, Craig Melton Ex-spouse, Workshop In College Meaning,